 |
|
|
|
Instructions to Replace VFD Controllers Instructions for Monodrive® replacement 1) Replace Monodrive® controller with standard single Phase control box. 2) Remove micro switch and plug hole 3) Install pside-kick® and wire power through pressure switch as per diagram.  Instructions for Subdrive® using three phase motors, (if replacing microswitch when Subdrive® controller still works or when using other three phase converters.) 1) Install pside-kick® per instructions. 2) Remove micro switch and move wires to the provided 40/60 mechanical pressure switch as per diagram. (EPS15/99 cannot be used with this.) 3) Wire controllers independent 2 wire on/off control to pressure switch as per diagram. or When Subdrive® controller fails 1) Install pside-kick® per instructions. 2) Replace three phase motor and Subdrive® controller with a standard single phase motor and control box. 3) Wire pressure switch as per diagram. Note: Verify existing pump wire size will work for 1 phase applications.  Instructions to Replace Grundfos® CU301 Controller Installation for SQE® controller replacement 1) Remove CU301 controller and transducer 2) Install pside-kick® 3) Wire pressure switch as per instructions below  |
| Cycle Stop Valves® is a registered trademark. All right reserved unless prior authorization is obtained. Cycle Stop Valves are patented: Patent number 5,988,984 and other patents pending. |
|
 |
||||